CHB 34 w/ factory fibreglass decks - boats - by owner - marine sale - craigslist (2024)

A very specific model of the popular 34’ CHB design, this “Puget Trawler” edition is a double cabin layout that can comfortably sleep six when using the salon settee as a third double berth. This model has aluminum framed salon windows and original nonskid decking.

SPECIFICATIONS:
CHB Double Cabin “Puget Trawler” Dimensions
LOA: 37’
Beam 11’ 9”
Draft 3’ 6”
Weight 20,000lb
Fuel – Two Steel tanks, 300 gallons total
Water – Two new aluminum tanks, total 120 gallon
Waste – One Poly tank, 30 gallons
MECHANICAL:
Perkins Sabre M-135, six-cylinder diesel
-Repowered in 2003 with 2,700 hours
-burns 1gph 6 knots. 2gph at 7.5/8 knots. 10.5 knots WOT
-All hoses replaced. Alternator rebuilt. Heat exchanger/ tranny oil cooler rebuilt. Impeller replaced. Paint touched up. Does not smoke, even on startup. Zero leaks.
-High output alternator installed (OEM is in spares inventory)
Borg Warner Velvet Drive gearbox- Rear output seal just replaced
1-1/4” stainless shaft, packing replaced last year
Two Racor 20 fuel/water separators
Morse helm controls at upper and lower helm
Lots of storage added under floor boards beside engine. Most spare parts, specialty tools etc are stored under the floor in engine room
Teleflex Steering ram rebuilt 2021
Steering fluid site gauge and easy fill added
Fuel tanks in excelent condition- with inspection ports

ELECTRICAL:
2- 150 AH lithium batteries for 300Ah house bank- 100% usuable AH
Sideshift ss350 bow thruster- 2 agm batteries in bow with all associated wiring- new 2022
Victron dc-dc charger for thruster bank
Engine Alternator rebuilt last year
Balmar smart regulator, boosts or bucks field wire on alternator based on temperature- Charges lithium batteries very fast from engine
Entec Marine model 4200-D genset 4.2 Kw, 518 hrs., Ferryman 18W diesel genset engine in stainless sound shield
-genset was pulled, valves adjusted, painted, all hoses replaced, heat exchanger rebuilt winter 2022 as preventative maintenance- This is a $12k genset if installed today
Outback FX model MT 2012, 2 Kw inverter, w/MATE helm control- 80A built in charger- for charging batteries fast with generator
Sterling Alternator protector
All 120v outlets replaced- most with usb plugs built in- all Leviton w/ stainless covers
LED bulbs throughout boat
LED engine room lighting/ with extra fixtures
Second fridge added in aft Cabin- tons of space and no need for a cooler on board
Much of the boat has been rewired or connections replaced
Garmin 9 inch fishfinder/ depth sounder (2022)
New smart plug 120v stainless socket on boat, w/ cord
Miscellaneous 30 and 20 amp shore and extension cord pigtails
Power panel pulled to rear of boat for downriggers, 70A fuse

ELECTRONICS:
Autohelm 6000 AutoPilot, both helms
Navionics on ipad for navigation/tides/weather
Furuno wifi radar- to second ipad- Radar lifted to accommodate flybridge
iCom MXA 5000 AIS receiver
Uniden UM 625 VHF with WHAM X4 wireless remote microphone
Garmin 160 C Blue fishfinder
Raytheon sounder/finder model 265
Ritchie HB740 helm compass
Grounds were gone through and wired to new divers dream zinc
Fast dc usb chargers at both helms

GALLEY, SALON and HEADS:
Espar D5 forced air diesel cabin heater- 5 outlets
New electric toilet in master bathroom
New faucet master bathroom
New faucet kitchen sink
New water lines 90% of boat
New outdoor shower/ transom washdown. HOT fresh water washdown for fish blood
Hot water tank replaced 2021
New main septic hose to black tank
Custom ordered teak dish rack
Knife/ spatula magnet
2-Red Dot cabin heater’s for engine heat while running
Taylor “Tundra” 12/120v refrigerator, model T42AC- New cooling fan behind
Magic Chef four-burner propane stove and oven
2-20 lb. propane bottles, regulator and safety solenoid
Jabsco macerator pump just rebuilt last week
New Rule rear bilge pump for sucking out bilge water at stuffing box, before it reaches bilge

DECK GEAR and ACCESSORIES:
44 lb. Lewmar “Bruce” anchor
200’ chain with 250’ line rode
New jabsco wash down pump, outlet under the pulpit
Ideal model CWM electric dual-capstan windlass, just rebuilt,with spare motor
New lewmar “up” windlass foot switch
Spare anchor in lazarette
Custom stainless paddle board rack- holds 2-3 paddleboards
Canvas Window covers
New Bug screens in all windows 2021
Windows professionally resealed 2021
5 portlight windows replaced 2021
Front bow hatch seal replaced, entire hatch removed and overhauled 2021
One red dot fan replaced
Dickinson stainless bbq with cover- plumbed into main propane tanks
Olympian wave6 heater for flybridge heat
Four flybridge lockers with cushion seats, cleaned and painted interiors
SeaWise hand crank lift on aft bulkhead for a dinghy (dinghy not included) ($8k new)

ACCESSORIES:
Perkins OEM alternator (new spare, replaced with high output version in 2003)
Replacement electric windlass motor
Belts, engine oil filters, Racor filters, espar parts, generator spares

ADDITIONAL INFO:
This CHB was delivered with these factory options when purchased new:
Flybridge designed in newer ‘Clipper Style’
Fiberglass folding radar mast
Fiberglass nonskid on cabin decks and main deck – no teak overlay
All stainless steel hardware
Raked stanchions and oversized

Boat is located on vancouver island
asking $94,900 Canadian which is currently around $69,000 usd